https://docs.opsero.com/op068/guides/Recent content in Guides on Opsero DocsHugoenCopyright (c) 2026 Opsero Electronic Design Inc.Mon, 23 Feb 2026 00:00:00 -0500https://docs.opsero.com/op068/guides/getting-started/Mon, 23 Feb 2026 00:00:00 -0500https://docs.opsero.com/op068/guides/getting-started/<h2 id="minimum-setup">Minimum setup</h2> <p>To start developing machine vision applications with the RPi Camera FMC, we recommend that you get setup with the minimum hardware and software requirements:</p>https://docs.opsero.com/op068/guides/programming/Mon, 23 Feb 2026 00:00:00 -0500https://docs.opsero.com/op068/guides/programming/<p>This section provides the details of the programming requirements to operate the RPi Camera FMC hardware and customise functionality.</p> <h2 id="cameras">Cameras</h2> <p>Configuration of the cameras must be done over the I2C buses and the procedural details for doing so, including I2C addresses, register addresses and so on, is entirely dependent on the cameras being used. For this reason, the camera configuration details fall outside the scope of this guide. For information on programming for specific camera devices, such as the Raspberry Pi camera v2, we suggest that you refer to the documentation of our <a class="link link--text" href="https://docs.opsero.com/op068/resources/example-designs/">example designs</a>.</p>https://docs.opsero.com/op068/guides/troubleshooting/Mon, 23 Feb 2026 00:00:00 -0500https://docs.opsero.com/op068/guides/troubleshooting/<p>This section describes some of the common issues that can arise when using the mezzanine card.</p> <h2 id="vadj-not-12v">VADJ not 1.2V</h2> <h5 id="problem">Problem:</h5> <p>The VADJ voltage applied to the FMC by the carrier card is not 1.2V (verified by probing the VADJ test point on the FMC).</p>